"Dolly Church" with two windows and side tower...
Posted: Wed Jul 12, 2017 7:41 pm
Greetings to all…
Here’s another “dolly” inspired project…according to my count, this is number 14 in the series…We have a couple of more on the works…another church and a house with a balcony…Lynn keeps finding new versions and sending them to me…
Now…a few notes…
Print out the PDF at 100%…
There is a square cardboard roof in the top of the tower…but is not shown on the pattern sheet…not sure the original had one or not…
The tower slips through the square hole in the roof and over the side wall via the “finger joint” slits…suggestion…make the body, then the tower, slip the tower over the wall, glue and let dry…then add the roof…
The church windows were posted earlier in a PDF…they measure about 3/8” wide x 1 ¼” tall…
I’ll continue to use the extra fine colored glitter on all the rest of my versions of the dolly reproductions…the gold and red look so good together…
My very best regards…
Howard…
Here’s another “dolly” inspired project…according to my count, this is number 14 in the series…We have a couple of more on the works…another church and a house with a balcony…Lynn keeps finding new versions and sending them to me…
Now…a few notes…
Print out the PDF at 100%…
There is a square cardboard roof in the top of the tower…but is not shown on the pattern sheet…not sure the original had one or not…
The tower slips through the square hole in the roof and over the side wall via the “finger joint” slits…suggestion…make the body, then the tower, slip the tower over the wall, glue and let dry…then add the roof…
The church windows were posted earlier in a PDF…they measure about 3/8” wide x 1 ¼” tall…
I’ll continue to use the extra fine colored glitter on all the rest of my versions of the dolly reproductions…the gold and red look so good together…
My very best regards…
Howard…