https://cardboardchristmas.com/forums/
Door opening template for accurate cutting lines every time https://cardboardchristmas.com/forums/viewtopic.php?f=4&t=31	Page 1 of 1

---

Author:	Howard [ Wed Nov 02, 2011 11:55 am ]
Post subject:	Door opening template for accurate cutting lines every time
It's a piece of cardboard with the door opening carefully measured and cut out with a hole punch, craft knife and straight edge... Align the template it where the door should go on the house you are making...trace around the opening with a sharp pencil...then cut out the opening... I've made several different ones for different size doors...but this is the one i use most of the time...it fits the PWD-3s that Ted has available...here's the link... http://www.papatedsplace.com/reproParts.html My very best regards to all... Howard Attachments: door opening template 001.JPG [ 210.17 KiB | Viewed 9726 times ]

---

Author:	Ruthann [ Wed Nov 02, 2011 7:36 pm ]
Post subject:	Re: Door opening template for accurate cutting lines every t
This is wonderful. I was using thick cardboard to cut some tiny doors, and I kept tearing the upper part above the opening.

---

Author:	Lynn [ Mon Nov 14, 2011 9:54 pm ]
Post subject:	Re: Door opening template for accurate cutting lines every t
What a good idea, I will be making some of these templates for myself!

---

Page 1 of 1	All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group http://phpbb.com/